AMS-1000 BOOST CONTROLLER

[NLRsystems]

If your not using AMS control you ll soon be beat by someone who does!





************* 950.00 *************





NLR is the leader in forced induction technology. The latest development is this controller. This controller does what others wish they could do. This unit will out perform ANY controller on the market! This unit can also be purchased to upgrade a current MSBC-1 set up. Take advantage of the latest technology from NLR ! The quickest and fastest bikes in the world use BOOST CONTROL FROM NLR !

AMS-1000 Features:
*Billet aluminum enclosure.
*will operate in ice cold conditions
*shock proof
*tested in high heat
*water proof
*terminal strip for neat and secure connections.
*4 mounting holes for easy and clean installation

Dimensions=
width 2.85
length=4.350
high=1.00
wieght= 12 oz.

NLR Advanced Forward Feedback Control.
Dynamic pressure operation! Controller will adjust itself when input pressure has changed in order to deliver the most accurate ramping and target termination.
Available with 3 bar GM map sensor or 60 psi stainless sensor.
Available with humphry 310 solenoids

-Motorola 50mhz 16 bit processor with integrated flash,Eprom data, and ram memory
-Enhanced timer system
-System software can be erased and reprogrammed by the factory for future software updates.
-User settings will remain for up to 20 years with no power applied. No back up batteries needed.
-128 x 64 pixel Extended temp(-20c to 80c) liquid crystal display
-Factory default RESET available in the options menu to restore controller to state it was out of the box from the factory.
-Options menu available to configure the input/output parameters to suit individual needs( NO MORE RELAYS).
-Controller is configured for operation from the factory .
- Factory reset option restores all options to original settings.
-Controller can be configured for different MAP sensors via options menu and /or factory programming.
-Ability to use multiple solenoids to tailor system operation to individual needs.
-Launch mode programmable from 0-60 psi

Scramble boost- give the controller an input and it will apply an amount of pressure that you program to the gate
thus increasing boost no matter where in the main program you are currently at.
Think of it as an emergency boost button(kinda like a shot of nitrous). Remove the signal and it goes back to you current program no matter where it is currently at.
(Can be used as a 2nd stage of boost on top of spring pressure)

Reduce boost- works the opposite of scramble. It will remove a pre programmed amount from the current program no matter where it is at.
If you spin stab a button and it will reduce power instantly.

Delay timer- can be activated or deactivated in the computer. 0-2 seconds.
Can be used in stage or time based control.
Ramps- can control applied rate on the addition of boost or subtraction of boost

Multiple operating modes:
-TIME BASED(up to 6 stages) programmable to 1 hundreth of a second.
-SHIFT INPUT(up to 6 stages),once again tell the computer if it will see +12volts or a ground.
-GPS( up to 6 gears)- self learning, can be used on anything with a voltage output. This will give a up and down boost range as it follows the gears.

Dual output channels available or the auxillary channel may be used for live boost pressure data viewing and datalogging.
(Basically there are 2 controllers in 1 box). Perfect for dyno tuning...your target pressure applied will be shown as well as live reading from your manifold.
Makes it accurate and easy for setting up your boost levels.
You can control multiple wastegates , solenoids, blow offs on supercharged systems ,air clutches, anything controlled by air.
Integrated Dual channel datalogger with 35 seconds of record for each channel. Graph view of logged data. Logged data will remain until it is erased by user.

Graph view of programmed settings.
Display backlight and contrast is user adjustable from the options menu.
Help screens and setup wizards to help with setup.
Most inputs can be configured for + 12volt or ground activation!!! NO MORE RELAYS
All inputs have input protection diodes. All outputs have integrated noise suppression devices to clamp fly back voltage from solenoids.
Outputs short circuit protected and over current protected(7 amp Maximum)
Reverse battery protection.

	AMS-1000 Boost Controller NLR is the leader in forced induction technology.

	NLR NLR is the leader in motorsports power and control technology.